Caple BXI900SS, Инструкция по эксплуатации

Страница: 6 / 10

6
If, having followed these instructions carefully, your cooker hood fails to work properly please carry out the following
checks.
Symptom CHECK
The cooker hood will not start
ƒ
Check the hood is connected to the electricity supply.
ƒ
Check that the fan speed control is set to 1, 2 or 3.
The cooker hood is not working
effectively
ƒ
The fan speed is set high enough for the task.
ƒ
The grease filter is clean.
ƒ
The kitchen is adequately vented to allow the entry of fresh air.
ƒ
If set up for recirculation, check that the charcoal filter is still
effective.
ƒ
If set up for extraction, check that the ducting and outlets are
not blocked.
The cooker hood has switched off
during operation.
ƒ
The safety cut-out device has been tripped.
ƒ
Turn off the hob and then wait for the device to reset.
•
If after all the se checks, the problem persist s, telephone the
Caple Service Centre 08 44 800 3830
,
quoting the model and serial number.
• Please note that it will be necessary to provide proof of purchase for any in-guarantee service calls.
• In-guarantee customers should ensure that the above checks have been made as the engineer
will make a charge if the fault is not a mechanical or electrical breakdown.
Electrical Requirements
ƒ
Any permanent electrical installation must comply with the latest I.E.E. Regulations. For your own safety this should
be undertaken by a suitably qualified electr ician who is on the roll of the National Inspection Council for Electrical
Installation Contracting (NICEIC).
ƒ
THIS PRODUCT MUST BE CORRECTLY EARTHED. The connection must be made as follows: -
o
Brown = Live
o
Blue = neutral
o
Yellow/Green = Earth
Electrical Connection
ƒ
Before connecting to the mains supply ensure that the mains voltage corresponds to the voltage on the rating plate
inside the cooker hood.
ƒ
This appliance is fitted with a 13 amp plug for connection to a suitable outlet which should be positioned for easy
access.
ƒ
If it is intended to connect directly to the electricity supply, the plug should be removed and the 3 core mains cable
and should be permanently connected to the electricity supply via an approved Switched Fused Spur outlet meeting
BS1363 Part 4, fitted with a 3 Amp fuse.
ƒ
This appliance conforms to BS 800: 1988 and EEC Directive No. 78 308 regarding suppression of radio and television
interference.
TROUBLESHOOTING
ELECTRICAL CONNECTIONS