Capetti Elettronica WSD12T-AV, Руководство пользователя

Страница: 4 / 8

WA0239E_WSD12T-AV_User Manual_R02
CAPETTI ELETTRONICA s.r.l. - Strada Stratta 57
10090 CASTIGLIONE TORINESE - TORINO - ITALY
VAT 04837130014 - Phone 011.981.98.11 - Fax 011.981.98.210
e-mail info@capetti.it - web www.capetti.it
4/8
WSD12T-AV
User Manual
Starting from the detection of the presence of the key, the LED performs periodic AMBER flashes at a rate of one every 2 seconds.
At each flash of light a different command is associated, to confirm the command you need, remove the WineCapKey immediately
after flash corresponding to the desired command. The TEST corresponds to the second pulse and activate the " Field Measurer "
function.
The datalogger will give back the radio signal quality through led flashes:
LED FLASHES RADIO SIGNAL QUALITY
5 green flashes Excellent
4 green flashes Good
3 green flashes Fair
2 amber flashes Sufficient
1 red flash Insufficient
1 red flash, 2 seconds
long Out of range – network
search
Picture 5 - Radio signal quality
Optimize reception selecting the best position: small movements can help.
If the signal is absent or insufficient at the install point, a WR12 router should be put between (
refer to "WineCapManager User
Manual
). The router itself must be located in a position where the signal level is at least sufficient.
The network will reconfigure itself automatically; the signal will be good again when the datalogger synchronizes with the router .
The link will not be reconfigured until completely lost by the datalogger . Because of this, in some cases it could be necessary to
force the operation. In such cases, put the datalogger in STANDBY mode, the run the TEST again (
refer to "WineCapManager" User
Manual
).
NOTE : The display equipped datalogger (
WD04T
) is recommended, as reading the signal quality is made easier with this model.
6. Stand alone USB datalogger installation.
Install the datalogger in appropriate place.
If the sampling process has not yet been activated you can start it through the WineCapKey .
Bring it closer to the sensitive point, wait for 2 flashes (
TEST
) and remove. The datalogger begins sampling according to your
settings through your PC.
Through the WineCapKey is possible to ask for the current status, bring it close to the datalogger for 1 flash (
STATE
) and remove it.