Edit: 30/07/19 | Rev A | Page:
15
2.2 Positioning in the vehicle length axis
- Position the
CAP2600 WORKSHOP™ in front of
the centre of the vehicle, so that the lens is
located between 20 cm and 80 cm in front of each
lamp.
- Identify two fixed points on the vehicle,
symmetrically placed in relationship to the central
axis
(for example: upper left and right corners of
the windscreen, non-deformed bonnet angles,
windscreen wiper nozzles if their base is not
deformed)
.
- Pivot the box to place the laser line on the
selected fixed points on the vehicle.
- Start the measurement procedure. During this
phase you will move the CAP2600 WORKSHOP™
in front of the headlight while keeping the angle
obtained with the laser. It is advisable to check its
position in relation to the vehicle between each
lamp.
WARNINGS
- Laser radiation
- Class 2M laser device
- Do not look directly into the beam nor directly observe using optical instruments.
- The vehicle must be empty of occupants when the laser beam is being adjusted.
- Laser adjustment must be used momentarily.
