11
3.3.
ADDING A SUPERVISOR
Press # to view the clock menu and then press 5 (“Admin”)
Press 2 (“Employee Level”). “Enter Administrator Card, PIN or Finger” is displayed
on screen
Enter 9970#. “Supervisor Demo User” is displayed for about 2 seconds followed by
“Enter Employee Num”
Enter the employee number of the supervisor followed by a #
“Is Supervisor?” will be displayed. Press # for “Yes” and * for “No”
“Is Administrator?” Press # for “Yes” and * for “No. Please note: only one
employee can be assigned the level of administrator i.e. 9970 will not be accepted
as the administrator card from this point onwards
“Set Employee Level Successful” will be displayed after successful completion of
the process
GENERAL USE
CLOCKING ON THE CS TIMECLOCK
Clocking on the CS TimeClock is quite simple. To clock using proximity cards or tags, hold
the centre of your employee card or tag in close proximity to the “Tag Here” circle on the
clock. To clock using a PIN number, type the number on the clock keypad and press #. If
the fingerprint reader is setup to use identification, the employee must firmly place their
enrolled finger on the fingerprint reader. If fingerprint verification is used, the employee
must first swipe their card or enter their PIN and then place the finger enrolled on that
card / PIN on the fingerprint reader.
The employee name, access area and TNA direction will be shown on the clock display.
For an IN clocking the clock will beep twice and light a green LED. For an OUT clocking
the clock will beep once and light a red light.
