3
INSTALLATION
After unpacking the product, check for any damage during transport. In case of problems, contact the dealer
or the After-Sales Service.
For built-in dimensions and installation instruction, see in below figures
The distance between the underside of the appliance and the separator panel must respect the
dimensions given in the figure (mini. 50mm).
In order to ensure the correct operation of the product, do not obstruct the
minimum required
clearance (min. 20 mm) on the worktop for air flow out.
If an oven is installed, make sure the oven is equipped with a cooling system.
Do not install the hob above a dishwasher or washing-machine, so that the electronic circuits do not
come into contact with steam or moisture which could damage them.
ELECTRICAL CONNECTION
Disconnect the appliance from the power supply.
Installation must be carried out by qualified personnel who know the current safety and
installation regulations.
The manufacturer declines all liability for injury to persons or animals and for damage to property
resulting from failure to observe the regulations provided in this chapter.
The power cable must be long enough to allow the hob to be removed from the worktop.
Make sure the voltage specified on the rating label located on the bottom of the appliance is the same
as that of the home.
