Canvas 059-1370-4, Руководство по сборке

Страница: 6 / 8

CASCADE ROCK WALL FOUNTAIN WITH LIGHTS
6
Place base on a clean level area outdoors.
Do not place on or near surfaces that may be damaged by water.
Fountain needs to be located near a GFCI (Ground Fault Circuit Interrupter)
outdoor electrical outlet.
To prevent back injuries, please ask for assistance when lifting.
1. Put the basin on a clean flat surface that cannot be damaged by water.
2. Put the pump into the basin then run the wire out through the center back hole
and lay the wire in the centre. There is a groove in the top so the wire will not get
pinched.
3. Mount the fountain wall section to the basin, make sure the hose goes through the
center hole. Connect the hose to the top of the pump. (Put the Wall gently into
place by pushing down or back and forth on the corners until it sets fully down
with no gap under the wall).
4. Fill the basin with clean water.
5. Plug into a properly grounded outlet.
6.
Test run and adjust the water flow by twisting the tab located on the front of the pump
to get the desired effect.
• If water does not flow out of unit, disconnect the power supply and verify that there are
no kinks in the hose. Shake the pump a little while underwater to remove any trapped air
in the unit.
• Remove any visible debris.
• Make sure there is enough water in the fountain. Fill to a level of 1–2" (2.5–5 cm)
below the rim of the base (Fountain – Lower Section).
• Connect and disconnect the power a few times. The pump should function.
• Wait a while in order to allow the water to circulate properly.
STEP-BY-STEP GUIDE
TROUBLESHOOTING
If you have questions regarding your product
or require warranty assistance, please call our
customer service helpline.
TOLL-FREE:
1-888-670-6684
BEFORE RETURNING
YOUR PRODUCT
CALL US,
WE CAN HELP
HAVING TROUBLE?
LET US HELP YOU!