Grand Soleil 40
- 35 -
Battery charger
The following instructions do not replace the information provided in the enclosed Manual
supplied by the Manufacturer.
•
The battery charger is an electrical appliance that works under tension..
•
It is fitted in a provided location under the chart table settee (see page 49).
•
It is ventilated by a blower fitted on the battery charger itself and by a grid that lies behind the
settee bow side of the bulkhead.
•
The battery charger has an automatic battery monitoring device, that distributes the necessary
power avoiding an excessive voltage load.
Instruction
•
Make sure that all the magneto thermal switches of the 220 Vac pane control are
disconnected (see page 48)
•
Connect 220Vac cable to shore supply, insert and turn halfway the other plug in the
socket on cockpit edge near the stern.
Never operate with wet hands and
barefooted.
•
Start the ”Main Breaker” switch (220 Vac) of the 220 Vac plant located on the 220 Vac
control panel (see page 48)
•
Connect the “battery charger” switch located in the 220Vca panel control (see page 48)
•
The 12 Vdc voltmeter located in the 12 Vdc control panel, indicates the presence of tension in
the 12 Vdc plant (see page 45).
Warning and caution
•
The normal electrical 220 Vac supply may have considerable sudden change of tension.
Caution:
The 220Vac installation has not been geared to bear voltage discrepancies of
over 5%. If this should occur cut off immediately 220Vac supply with its Main Breaker
in 220Vac panel,
located in the 220 Vac control panel under the chart table settee
(see
page 48)
