Cantek 303S, Руководство по эксплуатации и запасным частям

Страница: 4 / 26

1
SAFETY RULES FOR RIP SAW
1.
As with all machine, there is a certain amount of hazard involved with the use of this machine. Use the machine
with the respect and caution demanded where safety precautions are concerned. When normal safety precautions
are overlooked or ignored, personal injury to the operator can result.
2.
LIMITED WARRANTY This warranty does not apply to personal injury and defects due directly or indirectly to
misuse, abuse, negligence or accidents, normal wear-end tear, repair or alterations outside our faculties, or to a
lack of maintenance.
3.
IF YOU ARE NOT thoroughly familiar with the operation of this machine, obtain advice from your suspensor,
instructor or other qualified person. Or please contact the company who sold the machine to you, and request for
the correct instruction of operating. When you are not sure what the correct operation is, please do not use this
machine.
4.
IF AT ANY TIME YOU ARE EXPERIENCING DIFFICULTIES performing the intended operation, stop using the
machine! Then contact the distributor’s service department or ask a qualified expert how the operation shoul d be
performed.
5.
NEVER ALLOW UNSUPERVISED OR UNTRAINDED PERSONNEL TO OPERATE THE MACHINE. Make sure
any instructions you give in regards to machine operation is approved, correct, safe, and clearly understood.
6.
NEVER OPERATE A MACHINE WHEN TIRED, OR UNDER THE INFLUENCE OF DRUGS OR ALCOHOL. Full
mental alertness is required at all times when running a machine.
7.
MAKE all adjustments with the power “OFF” .
8.
NEVER LEAVE TOOL RUNNING UNATTENDED. TURN POWER OFF. DO NOT leave tool until it comes to a
complete stop.
9.
MAKE SURE wiring codes are recommended electrical connection instructions am followed, and that the machine
is property grounded.
10.
DISCONNECT machine from power source when make repairs.
11.
KEEP knives sharp and free of all rust and pitch.
12.
DO NOT operate this machine when the guard is removed.
13.
KEEP fingers and hands away from the cutting area.
14.
NEVER start the machine, with the workpiece in contact with the cutterhead.
15.
CHECK MATERIAL for loose knots and other defects before operating.
16.
MAKE SURE the workpiece is free from nails arid other foreign objects which could cause injury or damage to the
knives.
17.
MAKE SURE the knives are properly secured to the machine, as explained in the instruction manual, before
turning on power.
18.
REMOVE SHAVINGS only with the power “OFF”.
19.
KEEP HANDS away from the top surface of the board near the feed rollers.
20.
BEFORE LEAVING the machine, make sure the work area is clean.
21.
SHOULD any part of your machine be missing, damaged or fail in any way, or any electrical component fail to
perform properly, shut off switch and remove plug from power supply outlet. Replace missing, damaged or failed
parts before resuming operation.
22.
ATTENTION!! Before installation & operation, please make sure the worker has been trained and be affected
insurance on. Al so, for the dangerous machine, the seller in local has to insure “Product Liability Insurance” .