CanProx Proximity/Keypad Reader
Installation Instructions
August 2018 • Rev. 1.6
Page 14 of 14
Appendix
8-BIT BURST KEYPAD MODE
While in the 8-bit burst mode each key press results in the reader transmitting 8 bits of
data to the host.
The Proximity/Keypad Reader is usually shipped in 8-bit burst mode. However, if it was
programmed to output standard 26-bit Wiegand or Cansec 37-bit Wiegand then follow
the steps below to enable 8-bit burst:
1.
Cycle power to the reader.
2.
Present the Wiegand Keypad Data Mode control card to the reader – reader will
beep four times.
3.
Press the “#” key – reader will beep four times to indicate success.
4.
Press “*” key – reader should beep once to indicate 8-bit burst is enabled.
CanProx Proximity/Keypad Reader is compliant with the following organizations:
