CANOPY US LED CNP-1-50 Series Скачать руководство пользователя страница 2

Страница: 2 / 4

Page 2

Updated 09.21.12

CNP-1-50

INSTALLATION GUIDE

#44-000017

1. Using 4” hole saw, cut hole in canopy where fixture is to be mounted. Hole location needs to be centered be-

tween canopy ribs to allow wire harness/cover assembly to fit.

2. Install mounting plate assembly by folding mounting tabs in, insert mounting plate into 4” hole and secure by

tightening mounting tab screws using #2 Phillips screw driver. See Figures 1 and 2.

INSTALLATION INSTRUCTIONS

4” hole

Mounting tabs

FIG 1

FIG 2

Mounting tab

screws

FIG 3

FIG 4

3. Hang Canopy Fixture on mounting plate assembly by hooking hinge on mounting plate hook. Secure by sliding

locking plate forward into slot and tightening #6-32 locknut. See Figures 3 and 4.

Locking plate

Locknut

Содержание US LED CNP-1-50 Series

Страница 1: ...in Canada Disconnect power before installing the product or servicing it Wait until fixture has cooled down before installing or servicing the fixture MIN 90 C SUPPLY CONDUCTORS WARNING l l l l l MODE...

Страница 2: ...ver assembly to fit 2 Install mounting plate assembly by folding mounting tabs in insert mounting plate into 4 hole and secure by tightening mounting tab screws using 2 Phillips screw driver See Figur...

Страница 3: ...ssembly and make power connections using approved electrical connector Connect Red wire to Red wire and Blue wire to Blue wire See Figure 6 INSTALLATION INSTRUCTIONS FIG 5 FIG 6 FIG 7 FIG 8 6 Pack exc...

Страница 4: ...etal screws supplied Insure location allows wire harness to reach low voltage side of power supply box See Figure 10 4 Make internal primary side high voltage power connections by connecting wires Bla...