3
3-14
Performing Setup from the Control Panel
The message “No AppleTalk zone found” may mean your network has no zones, or the
network cable is not connected (see page 6-4). Choose OK to dismiss the message.
TCP/IP Setup options
When you set an IP address, subnet mask, or gateway address for the ColorPASS
during Setup, you can allow the ColorPASS to get these addresses automatically from a
DHCP, BOOTP, or RARP server. First, turn on or reboot the ColorPASS and allow it
to reach Idle. Next, make sure the DHCP, BOOTP, or RARP server is running.
Finally, perform ColorPASS Setup.
To configure the ColorPASS for TCP/IP, choose TCP/IP Setup.
Choose Ethernet Setup and enter the appropriate settings. Choose each network
type you use (Ethernet and/or Token Ring) and enter the appropriate settings.
Token Ring Setup appears as an option only if you have enabled Token Ring in Port
Setup.
N
OTE
:
Concurrent use of Ethernet and Token Ring is not supported on the
ColorPASS.
Exit Protocol Setup
AppleTalk Setup
TCP/IP Setup
IPX/SPX Setup
Protocol Setup
Exit TCP/IP Setup
Ethernet Setup
Token Ring Setup
TCP/IP Setup
Содержание Z5000
