(14/28)
・
Modes of NMPJ
Four modes are available. Each mode is different in the number of computers and projectors that can
be connected and the functions that can be used.
Mode
PC
PJ
Direct
1
1
Meeting
10
6
Classroom
10
6
Broadcast
1
12
・
Version of NMPJ
Because there are different versions, check the NMPJ manual for compatibility issues.
●
Precautions when inputting analog PC signals.
If inputting analog PC signals, it is necessary to take the following precautions.
①
This product does not support image signals with a dot clock of over 162MHz due to hardware
restrictions.
②
Normally, image output equipment, such as computers, automatically read the EDID information from
the projector, and output image signals that can be displayed by the projector.
③
However, depending on the cable that is used, there may be cases where conduction lines for
communicating EDID information are not installed in the cable.
The following is the pin layout for a Dsub15 connector.
A cable with conduction lines for Nos. 9, 12, and 15 is necessary.
Unless there are conductions lines for these pins, the image output equipment will not be able to obtain
EDID information from the projector, and will output image signals that cannot be displayed by the
projector.
④
Even if a 5BNC cable is used, EDID information is not communicated, and settings must be specified on
the output equipment side so that image signals that can be displayed by this product are output.
