WUX500ST
User Commands
-63-
MAIN
Unit control panel emulation
Format
Setting
Command
MAIN=<Side control emulation button parameters:ID>
Response
i:OK
Reference
Command
-
Response
-
Note: See "Error list" for any response other than the above.
< Side control emulation button parameters:ID >
Parameter
Meaning
Operation
Remarks
POWER
POWER
POWER_OFF
-
Power OFF
MENU
MENU
INPUT
INPUT
AUTOPC
AUTOPC
KEYSTONE
KEYSTONE
UP
UP
UP+REP
Button press start
DOWN
DOWN
DOWN +REP
Button press start
LEFT
LEFT
LEFT +REP
Button press start
RIGHT
RIGHT
RIGHT +REP
Button press start
OK
OK
*-REP
-
Button press end
Environment
Power mode restriction
Input
LAN
WiFi
RS-232C
SL0 SL1 SL3 PM ON SL0 SL1 SL3 PM ON ST PM ON D-RGB A-RGB COMP HDMI HDBT LAN USB
No
signal
No Yes Yes Yes Yes No No No No Yes Yes Yes Yes
Yes
Yes
Yes
Yes
Yes Yes Yes
Yes
Remarks
(1) Parameters with "+REP" indicates "Button press start" (same state as when the front panel button
is held down). Be absolutely sure to send the '*-REP' parameter, and end the button pressing last
of all.
The button pressing is ended in the cases below as well.
When buttons on the panel or the remote are operated
When some command has been received
(2) When ceiling mount setting is made, functions of UP/DOWN/LEFT/RIGHT buttons on the unit
control panel are reversed. But the "MAIN" command's UP/DOWN/LEFT/RIGHT are unaffected
and always work in the same way as when installed on the floor.
(3) Adjust the time between each button press using the application.
(4) When a button press request is accepted properly, the projector returns "i:OK" even when the
function is inexecutable.
(5) When a button press request is accepted properly, the projector will behave in the same manner
as when the button on the unit control panel is pressed.
