Setting the User Bit
64
Setting the User Bit
The user bit display can be selected from the date or the time of recording, or an identification code
consisting of 8 characters in the hexadecimal system. There are sixteen possible characters: the
numbers 0 to 9 and the letters A to F. The user bit will be output from the HDMI OUT terminal.
1 Open the [User Bit Settings] screen.
>
[
3
#
Recording Setup]
>
[User Bit Type]
>
[
i
]
• To set the time for the user bit, select [
Time] instead; to set the date for the user bit, select
[
Date]. Then, select [
X
]. The rest of the procedure is not necessary.
• The user bit setting screen will appear with the orange selection frame on the leftmost digit.
• To reset the user bit to [00 00 00 00], select [Reset].
• Select [Cancel] to close the screen without setting the user bit.
2 Select the digit you want to change and then select [
Í
] or [
Î
] to change it as necessary.
3 Select another digit you want to change.
4 Change the rest of the digits in the same way.
5 Select [OK] and then select [
X
].
NOTES
• The user bit will not be recorded with clips that are recorded to an SD card.
Operating modes:
