Canon REALiS SX80 Mark II D, Руководство пользователя

Страница: 5 / 25

5
CHAPTER 1 • Introduction
Configuring the Network Settings of the Software C14
When installation of this software is complete, run the software and configure the discovery
settings of the network for discovery.
Starting the Software 1.4.1
Click the Windows [Start] menu and select [All Programs], followed by
1
[Projector Monitoring Software] and [Projector Monitoring Software].
Main screen of this software will display.
Configuring the Discovery Settings 1.4.2
Configure the network range for discovering projectors. Methods vary depending on "SNMP
V1/V2c/V3" and "LV Series". Configure each protocols respectively.
For SNMP V1/V2c/V3 ■
When using "SNMP V1" / "SNMP V2c" / "SNMP V3", you can specify a broadcast address or
IP address range for discovery. Select a protocol type and configure the range for discovery.
Configure SNMP V1/V2c/V3 with the following procedures. Configuration can be done with
the same procedures. SNMP V3 is used in this example.
From [Discovery settings] of the [Option] menu, select a name of protocol
1
([SNMP V1] / [SNMP V2c] / [SNMP V3]) to configure.
[Discovery settings] dialog will display.
Place a checkmark in [Enable (Protocol Name)].
2
Remove a checkmark if protocol is not used for discovery.
COP
Y