Canon PIXMA MP750, Руководство по обслуживанию, Страница: 65 / 135

1 - 59
NOTE:
The T1 timer for the transmitter (wait time after a CED, V21 flag, or ANSam significant
signal is detected until the next significant signal is detected) is fixed at 35 seconds.
[Parameter 11]
Set the T1 timer for the receiver (wait time after DIS transmission starts until a significant signal is
received).
If frequent errors occur during reception (2 instances) because of line connection conditions, raise
the value of this parameter.
#7 PRINTER (printer function settings)
2. NUMERIC PARAM.
No. Function Selecting range Default setting
05 Trailing edge margin 0 ~ 9999 5 ( 5 mm)
[Parameter 05]
Sets the print image trailing edge margin.
5. INK ABS CAPA
This switch allows the waste ink capacity stored in the PCNT board to be checked or entered.
[SUCTION]
At #5 INK ABS CAPA, you can check or register the capacity of waste ink ejected during the
cleaning operation. For the waste ink capacity registration, register a value between 0 – 100
(%) with the numeric keys.
The absorption amount of the waste ink absorber is set based upon the amount that the BJ
cartridge has ejected.
The settings of the waste ink capacity are stored in EEPROM of SPCNT BOARD.
When replacing the SPCNT BOARD, check the waste ink capacity before the replacement, and
register the waste ink capacity at the new SPCNT BOARD after the replacement.
6.CDR ADJUST
At #6 CDR ADJUST (CD-R Print writing positi on adjustment), you can adjust the writing
position in X and Y directions within the following range.
+/-0.0mm, +/-0.1mm, +/-0.2mm, +/-0
.4mm, +/-0.6mm, +/-0.8mm, +/-1.0mm
You can also perform this adjustment from “CD-LabelPrint” or “Easy-PhotoPrint”.