Canon PC880, Руководство оператора

Страница: 16 / 58

Canon PC880/860 Operator’s Manual ENGLISH
16
Installing the Cartridge
6
Grip the end of the cartridge, and pull it out of the copier.
NOTICE:
I
Although the cartridge comes already installed in the main unit, you
cannot make copies until after you have completed the following steps.
...............................
7
Hold the cartridge level so that the side with the written
instructions is facing upward. Rock the cartridge several times at
a 90
!
angle to evenly distribute the toner in the cartridge.
...............................
8
Place the cartridge on a flat, level surface (e.g., a desk or table).
Peel the sealing tape grip from the end of the cartridge. Grasp the
grip and pull the sealing tape out in the direction of the arrow
mark away from the cartridge.
CAUTION:
I
When removing the sealing tape, take care not to allow the toner on
the sealing tape to come into contact with your hands or clothing. If you
get toner on either your hands or clothing, wash immediately with cold
water. Washing with warm water will set the toner and make it
impossible to remove.
REQUEST:
I
Do not pull the sealing tape out at an angle. If the sealing tape breaks
before being pulled out fully, you will not be able to use the cartridge.
I
Do not press down forcefully on the cartridge.
MEMO:
I
The sealing tape grip is affixed to the end of the cartridge. Before
pulling out the tape, be sure to peel it from the end of the cartridge.
Then, pull the tape out slowly from the cartridge.
I
The sealing tape is approximately 50 cm long. Be sure to pull the
sealing tape completely out of the cartridge.
...............................