1. Remove the Corona Wire Assembly by prying out the two black tabs located on the side with the metal drum axle plate.
Clean the corona wire and cage with a cotton swab dipped in 99% pure Isopropyl alcohol
2. To remove the Waste Chamber cover, apply a small amount of pressure against the opposite side of the spring, and lift
the cover off.
3. Remove the two large Phillips head screws on either end of the Wiper Blade, and carefully pry off the alignment holders
Remove the four small Phillips head screws, or a strip of black tape (depending on the cartridge version you have),
and pry the blade off. Wipe the blade off with a toner magnet when removed.
WARNING:
Be very careful not to bend or otherwise damage the small thin recovery blade located next to the Wiper
Blade. If this blade is bent down lower than the height of the wiper blade, toner will accumulate on top of the blade and
spill into the printer. If the blade does get bent, it may be possible to carefully bend the blade to a height equal to, or
slightly higher than the Wiper Blade. Make sure that the edge of this blade is even across its entire length. If the blade
cannot be repaired, replace it with our part # RB-1585.
4. Remove the packing blade assembly by prying the top blade up with a small common screwdriver, the bottom blade will
come up with the top. Vacuum the waste area clean, being careful of the recovery blade.
5. Re-install the packing blade assembly, wiper blade, alignment pins, all screws. Make sure that the small tab end of the
packing blade is set into the white gear.
6. Clean and re-install the Corona Wire Assembly.
7. Re-install the tan cover.
C
LEANING
T
HE
T
ONER
S
UPPLY
H
OUSING
1. Pry out the fill plug located on the side of the toner supply. Dump out any remaining toner and vacuum clean.
NOTE:
Before vacuuming, rotate the magnetic roller and, observe the layer of toner on the roller surface. The toner
should form an even consistent layer with no clumps or lumps showing. Should the layer of toner be thicker in some
areas, the Magnetic Roller should be cleaned using a dedicated magnetic roller cleaner (MRC-16) or 99% Pure
Isopropyl Alcohol. Always remove the roller before cleaning and make sure it is completely dry before re-installing it.
2. To remove the Magnetic Roller, take off the gear assembly on the side of the hopper, and lift out the magnetic roller..
3. Once a seal becomes available, it can be inserted through the fill plug side. Until then we recommend that this cartridge
be hand delivered only.
4. Fill the supply with toner and check for leaks.
R
E-ASSEMBLE
T
HE
C
ARTRIDGE
Reset the counter by turning the small white gear closest to the color wheel clockwise until it stops, and install on the waste
Chamber.
Coat the OPC drum with Padding Powder (DPP), and install in the cartridge. Install the drum axle pin, and 2 screws.
Install the two springs.
Place the two halves together, and re-install the end cap with the three plastic clips.
Test and box the cartridge.
This cartridge does not use a felt wand.
© 2003 Summit Laser Products, Inc. Any attempt to reproduce any part of these instructions without the written consent of
Summit Laser Products, Inc is prohibited. All registered trademarks are the property of their respective owners.
R
ECOMMENDED
S
UPPLIES
Microsoft OLE DB Provider for ODBC Drivers error '80004005'
[Microsoft][ODBC Microsoft Access Driver]General error Unable to open registry key 'Temporary (volatile) Jet DSN
for process 0x3464 Thread 0x954 DBC 0x8437024 Jet'.
/script/catSearch.asp, line 58
