Rebooting/Resetting the Camera
24
Rebooting/Resetting the Camera
This section describes how to operate the REBOOT switch and the RESET switch.
To reboot/reset the camera by menu operation with the buttons* or via the network, refer to the respective
operation guide.
* Rebooting is not available by menu operation with the buttons.
Rebooting
To reboot the camera, press the REBOOT switch.
Resetting
To reset the camera to its factory default settings, press the RESET switch and REBOOT switch while checking
the LED in the following order.
1) Hold the RESET switch down, and press the REBOOT switch.
2) After holding down the RESET switch for at least three seconds, release the REBOOT switch.
3) After the LED starts to blink, release the RESET switch.
When the blinking has stopped, the unit has finished resetting (it may take a few minutes).
NOTES
• If you restore factory default settings, you will become unable to connect to the network because the
administrator account is also initialized.
Use the Camera Management Tool to configure the initial settings.
REBOOT switch
RESET switch
LED
