Canon LBP5050 Series, Руководство по обслуживанию

Страница: 55 / 104

Chapter 3
3-7
F-3-35
8) Free the 2 claws [1] in the direction of the arrow, remove the link shaft
stopper [2] in the direction of the arrow and remove the link shaft [3].
F-3-36
9) Free the 2 hooks [1] of the main drive assembly from the claws [2] in the
direction of the arrow and remove the main drive assembly [3].
- 7 screws [4]
F-3-37
Points to Note at Installation
When installing the link shaft, be sure to fit the boss [1] of the link shaft into
the groove [2] of the arm of the main drive assembly and install it.
[1] [2]
[2]
[1] [3]
[2]
[1]
Points to Note at Installation
Check to see that hook [2] of the gear [1] of the sub drive assembly is
situated at the correct position as shown in the following figure.
If it is not situated at the correct position, rotate the gear [1] in the direction
of the arrow to adjust the hook [2] to the correct position.
Check to see that the ITB link assembly [2] of the main drive assembly [1]
is set to the correct position as shown in the following figure.
If it is not set at the correct position, rotate the ITB link assembly [2] in the
direction of the arrow to adjust it to the correct position.
Be sure to fit the shaft [3] of the main drive assembly into the hole [4] of the
end plate and attach it.
[4] [4]
[4] [3]
[2] [1] [2] [1]
[1] [1] [2]
[2]