Canon iR2200 Series, Руководство по обслуживанию

Страница: 462 / 768

COPYRIGHT © 2001 CANON INC. 2000 2000 2000 2000 CANON iR2200/iR2800/iR3300 REV.0 MAR. 2001
CHAPTER 3 STANDARDS AND ADJUSTMENTS
3-22 T
5.9 Adjusting the Height of the Side Member
5.9.1 Before Making Adjustments
1) Disconnect the machine from its host
machine, and then connect it once gain,
thereby finding out whether the impact
of connection causes the host machine
to slide over or the machine to wobble.
If any such problem is noted, adjust the
height of the side member as follows;
otherwise, these steps need not be per-
formed:
5.9.2 Making Adjustments
1) Connect the machine to the host ma-
chine.
2) Take out the paper from the deck.
3) Remove the right cover of the machine.
4) Loosen the two fixing screws [2] of the
side member [1].
5) With the side member in contact with
the floor, tighten the fixing screws. At
this time, refer to the index so that the
left and right screws match against the
same index.
F03-509-01
6) Disconnect the machine from the host
machine, and then connect it once
again. If it can be done without extra
force, mount the right cover for the ma-
chine, and put the paper back into the
deck. If extra force is needed, go to the
next step.
7) Check the index of the side member.
8) Loosen the fixing screws of the side
member.
9) While referring to the index, raise the
side member 1 mm, and then tighten the
fixing screws.
10) Mount the right cover, and then put the
paper back into the deck.
[1]
[2]