![background image](http://html.mh-extra.com/html/canon/ip6700d-pixma-color-inkjet-printer/ip6700d-pixma-color-inkjet-printer_printing-manual_57946072.webp)
70
Cannot Print Properly through Wireless Communication
The following are the causes of the trouble may occur when printing through infrared
communication.
For the trouble when printing through Bluetooth communication, refer to the
Bluetooth
User’s Guide
.
PictBridge-compatible digital cameras can be connected to your printer for
direct printing.
A communication time out occurs if printing takes a long time or if it takes
too much time to send data. This may stop printing. In such a case,
disconnect the cable between the printer and the camera, and reconnect it.
Then, turn the camera on, if it does not automatically turn on just by
connecting the cable. If the problem is still unresolved, select some other
photo and check if it can be printed or not.
Depending on the model or brand of your PictBridge Compliant device, you
may have to select a print mode before connecting the device. You may also
have to turn on the device or select Play mode manually after connecting the
device to the printer. Perform necessary operations according to the
instruction manual supplied with your device.
The print head nozzles may be clogged if printing becomes faint or colors
are incorrect. See “When Printing Becomes Faint or Colors are Incorrect” on
page 52.
If the paper is curled or its surface is scratched during printing, make sure
that you are using the correct type of paper. If this error occurs even when
you are using the correct type of paper, select ON
ON
ON
ON in the Prevent paper
Prevent paper
Prevent paper
Prevent paper
abrasion
abrasion
abrasion
abrasion menu. See “If the printed surface is still scratched” on page 64.
To disconnect the cable connected between a digital camera and printer,
follow the procedure below.
1.Disconnect the cable from the printer.
2.Turn off the digital camera.
3.Disconnect the cable from the digital camera.
When disconnecting the cable, be sure to hold the connector by its sides.
For the errors indicated on the camera and their solution, also refer to the
user’s manual of the camera. For other troubles on the digital camera,
contact the manufacturer.
Possible Cause
Try This
The installation place, distance,
and/or angle is improper
Check the installation place, distance, or angle.
See “Performing Infrared Communication” on page 42.
During infrared communication,
infrared rays were interrupted or
another infrared communication
device is operating nearby
If infrared communication between the infrared ports of the printer and the mobile
phone is interrupted by any obstacle for ten and several seconds or longer during
printing, the paper on which data is being printed is ejected and the printer is
reset. Remove the obstacle and retry printing.
If an infrared communication device is operating nearby, interference can occur
and fail in printing the document to the end. While printing a document through
infrared communication, do not operate another infrared communication device,
such as a remote controller of a TV, nearby.
The requirements for infrared
communications with the mobile
phone are not satisfied
Use the mobile phone or PDA, which has an IrDA port compatible with the image
data transfer using the infrared communication.
iP6700D_DPG_US.book Page 70 Thursday, April 13, 2006 11:05 AM