Procedure
Detail
Note
Time
Multifunction professional Puncher- A1
DIE Maintenance
continued.
Every
200K
copies should be
inspected and lubricated
Multifunction professional Puncher- A1
Clean any loose chads
inside the Pro Punch
CAUTION: Make sure you disconnect the Professional Puncher from its
power source before cleaning. Failure to observe this warning could
result in death or injury.
Empty Hole Punch Waste
Remove dirt, paper dust,
NCR residue and toner from
the Pro Punch and Finisher
rollers
M14
Die Set Shoulder Bolts Lubrication.
1.
Lubricate with high quality Teflon-based
grease.
2.
Apply grease to Shoulder Bolts and
Springs [1]
3.
Wipe up any excess grease.
M15
1
. Occasionally remove the covers and remove paper dust and chips.
Paper dust can accumulate throughout the punch including around the
motor and other electrical components. Use vacuum cleaner if possible.
A small paintbrush can also be used but extreme care should be used
around electrical components.
2.
Clean non-electrical components with alcohol, an approved cleaner,
or soft cloth moistened with mild detergent and warm water.
3.
Clean the Rollers with alcohol.
Base Cleaning : Chips and paper dust falls to the bottom of the punch.
Clean every service call. ( Clean with a vacuum cleaner )
Chip Bin Cleaning: Empty out the bin every service call. Clean, especially
at the holes on the sides of the bin
Die Guide Cleaning:
every
500k
cycles
1. Remove the Die Set
and clean the guide[1]
with a vacuum cleaner.
Clean
Do not need to do this every service
call. Recommended at 500K.
depending on customer use and
environment.
DIE Cycles
: This displays the
# of cycles punched with the
Die set that is currently
installed in the machine.
Mul
ti
-
Funct
ion
P
rof
es
sional
P
uncher
-A1
Main
te
n
an
ce
Pr
oces
s
iRADV C7580i/C7570i/C7565i Advance Maintenance Guide
