Canon IMAGERUNNER ADVANCE C5051, Руководство по обслуживанию

Страница: 50 / 160

1
Routine Maintenance
Replacing the Toner Cartridge 1-38
Replacing the Toner Cartridge
When there is only a small amount of toner remaining inside the machine, the message <Black toner is low. Replacement
not yet needed.> appears on the touch panel display. You can continue printing, but at this time you should purchase a new
toner cartridge of the indicated colour, to have it available when needed.
When the message <Replace toner cartridge. (black)> is displayed on the touch panel display, press [
] on the bottom
right and replace the toner cartridge for the displayed colour.
When the Black toner or all of the toners run out completely and prints can no longer be made, a screen with instructions on
how to replace the toner cartridge appears on the touch panel display. Follow the procedure described below to replace the
toner cartridge.
If you press [Close], you can continue operations, such as setting modes and scanning originals, even if you do not replace the
toner cartridge immediately.
Do not burn or throw used toner cartridges into open flames, as this may cause the toner remaining inside the cartridges to
ignite, resulting in burns or a fire .
Keep toner out of the reach of small children . If toner is ingested, consult a physician immediately .
Take care not to allow toner to come into contact with your hands or clothing . If toner gets onto your hands or clothing, wash
it off immediately with cold water . Washing it off with warm water will set the toner, and make it impossible to remove the
toner stains .
Use only toner cartridges intended for use with this machine.
Do not replace toner cartridges until the message prompting you to do so appears.
You can replace a toner cartridge while the machine is printing.
The colour of the toner to be replaced is displayed on the touch panel display. If multiple toner cartridges must be replaced, replace the
toner cartridges in the following order: Black, Yellow, Magenta, Cyan.
If you continue copying or printing in black-and-white after cyan, magenta, or yellow toner runs out, do not remove the depleted toner
cartridges from the machine.
You can display an error message informing the user that the remaining toner is low. For instructions on displaying the remaining toner
error message, see e-Manual > Settings/Registration. For instructions on deleting the remaining toner error message, see e-Manual >
Settings/Registration.
When the message <Black toner is low. Replacement not yet needed.> appears, approximately 5% of the toner is left. It is recommended
that you get a new toner cartridge ready for replacement before the displayed toner colour runs out.
Complete instructions on how to replace the toner cartridge can be accessed by pressing [Previous] or [Next] on the touch panel display.
If toner runs out during a print job, the remaining prints are made after you replace the toner cartridge.
If black toner is left, you can continue copying and printing in black-and-white. However, if a job is interrupted because cyan, magenta, or
yellow toner runs out, copying and printing in black-and-white is only possible for functions other than the function being used for the
interrupted job.
After replacing toner cartridges, if printed colours are different from the colours printed before you replaced the toner cartridges, perform
an Auto Adjust Gradation in Adjustment/Maintenance (from the Settings/Registration screen). (see e-Manual > Settings/Registration.)
•
•
•
•
•
•
•
•
•
•
•
•
•