Canon imageRUNNER 5075, Справочное руководство, Страница: 200 / 502

Specifying Common Settings 4-54
4
C
u
sto
m
iz
ing Settings
Limiting Functions
If a problem frequently occurs when using the Finishing modes, such as Offset
Collate and Staple, you can temporarily limit the use of these finishing modes by
setting Limited Functions Mode to 'On'.
In addition, when the Service Call Message screen appears indicating a finishing
mode malfunction and you temporally set the Limited Functions Mode to clear the
Service Call Message screen, you can deactivate the Limited Functions Mode by
setting this mode to 'Off' from the Additional Functions screen. However, after the
Limited Functions Mode is deactivated, the Service Call Message screen may
appear again, unless the cause of the malfunction is cleared. (See "Setting the
Limited Functions Mode from the Service Call Message Screen," on p. 8-100.)
NOTE
[Limited Functions Mode] is displayed only if an optional finisher is attached.
1
Press (Additional Functions)
➞
[Common Settings]
➞
[Limited Functions Mode].
2
Select [On] or [Off]
➞
press [OK].
NOTE
The Limited Functions Mode is enabled only after you restart the machine (the
main power switch is turned OFF, and then back ON). For instructions on restarting
(turning the main power switch OFF and then ON) the machine, see "Main Power
and Control Panel Power," on p. 1-16.
Forcing to Output Excess Tab Paper
You can set whether to force to output excess tab paper that was not used for a
Copy or Print job that included tab taper. For more information on copying or
printing on tab paper, see Chapter 4, "Special Copying and Mail Box Features," in
the
Copying and Mail Box Guide .
1
Press (Additional Functions)
➞
[Common Settings]
➞
[Unfinished Tab Paper Forced Output].
2
Select [On] or [Off]
➞
press [OK].