2
Prepare the printer for use by installing it and connecting the power cord.
Preparations
1
Install the printer. You can use the following three methods for installing the printer.
• Install without a stand on a table
Proceed to step 2.
• Install with the optional stand
Assemble the stand and install the printer referring to the Printer Stand Setup Guide included
with the stand.
After installation, proceed to step 4.
• Install with the spectrophotometer unit
The stand is required if you are using the spectrophotometer unit. Assemble the stand and
install the spectrophotometer unit and printer by referring to the Printer Stand Setup Guide
and then the "SU-21 Spectrophotometer Unit Setup Guide". After installation, proceed to step 4.
MEMO
• The stand is a standard accessory in some locations.
2
Remove the printer from the box and
remove the packing materials from the
top of the printer.
3
At least three people are needed to lift the
printer by its carrying handles (a), located
under its right and left ends, and to place
it on a table or other flat surface.
a
a
• The printer weighs approximately 54 kg
and requires at least three people to lift
it by its carrying handles (a) under its
right and left ends.
4
Remove all the orange tape from the roll
feed unit (a). Remove the roll holder (b)
from the roll feed unit (a) and remove the
protective materials and all the orange
tape on the two holder stoppers (c).
b
c
a
5
Remove the orange tape on the top cover
(a) and the ejection guide (b) and all the
packing materials.
After removing the orange tape and
packing material from inside the ejection
guide (b), reattach it.
a
b
MEMO
• If the Spectrophotometer Unit
(optional) is attached, the
Ejection Guide (b) does not need
to be reattached.
6
Lift the belt stopper (b) from the carriage
shaft (a) and pull it towards you to remove
it.
a
bb
MEMO
• The belt stopper is used when
transporting the printer. Keep
the belt stopper after removing
it, in case the printer needs to be
moved again.
7
Close the top cover.
8
Plug the power cord into the power supply
connector on the back of the printer and
plug the other end into an electric outlet.
