Canon FAXPHONE L75, Руководство по обслуживанию

Страница: 103 / 183

4-10
LASER CLASS 1060P Chapter 4: Maintenance & Service
“CHECK PRINTER” (##322~##324)
Check the displayed error code and see the measure to eliminate the error. ( See Page 4-21 .)
“CHECK SUBADDR/PSWD” (#083/#102)
Cause:
Password/subaddress does not match.
Solution:
Contact the other party and confirm that the subaddress/password that you are using
are correct.
“CLEAR PAPER JAM”
Cause: Paper jam.
Solution: Clear the paper jam.
“DATA ERROR”
Cause: The registration data in the SRAM was destroyed and a checksum error occurred due
to a dead lithium battery or SRAM failure.
Solution: (1) Press the
Set
button.
(2) Replace the lithium battery.
(3) Replace the SCNT board.
“DOC. TOO LONG” (#003)
Cause: The document is longer than 39.4"(1m).
Solution:
Use a copy machine to make a reduced copy of the document, then send again.
Cause:
It took more than 32 minutes to send, copy, a document or receive a document.
Solution: Divide the document and send or copy each part separately. Contact the other party
and have them divide the document and send each part separately.
“HANG UP PHONE”
Cause: The handset or the extension telephone is off the hook.
Solution: Put the handset or the extension telephone back on the hook.
“LOAD PAPER”
Cause:
The fax is out of paper.
Solution:
Add more paper to the sheet feeder.
“MEMORY FULL” (#037)
Cause:
The fax’s memory is full because it has received too many documents.
Solution: (1) Print out any documents which are stored in memory. Then start the operation
again.
(2) If the memory contains any facsimiles you don’t need, delete them.
Cause:
The fax’s memory is full because you tried to send too many pages at once.
Solution: Divide the document and send each part separately.
“NO ANSWER” (#005)
Cause: The receiving fax machine does not answer.
Solution: Make sure you dialed the correct number. Try again later.