Canon EOS Rebel T4i 18-135mm IS STM Lens Kit, Инструкция по эксплуатации

Страница: 125 / 372

125
3
Noise Reduction Settings
N
You can reduce noise in long exposures.
1
Select [Long exp. noise
reduction].
Under the [
z
3 ] tab, select [ Long
exp. noise reduction ], then press
<
0
>.
Long Exposure Noise Reduction
About [Multi Shot Noise Reduction]
The following functions cannot be set: AEB, WB bracketing, [
z
3: Long
exp. noise reduction ],
1
+
73
/
1
. If any of these has already been
set, [ Multi Shot Noise Reduction ] cannot be set.
Flash shooting is not possible. The AF-assist beam will be emitted according to
the [
5
4: Custom Functions (C.Fn) ]’s [ 4: AF-assist beam firing ] setting.
You cannot set [ Multi Shot Noise Reduction ] for bulb exposures.
If you turn off the power or change the shooting mode to a Basic Zone
mode, movie shooting, or bulb, the setting will change to [
Standard ].
If the images are greatly misaligned due to camera shake or if there is a
moving subject, the noise reduction effect may be minimal.
If you are handholding the camera, keep it steady to prevent camera
shake. Using a tripod is recommended.
The image alignment may not function properly with repetitive patterns
(lattice, stripes, etc.) or flat, single-tone images.
Recording the image to the card will take longer than with normal
shooting. During the processing of the images, “
BUSY ” will be displayed
and you cannot take another picture until the processing is completed.
[
z
3: Dust Delete Data ] cannot be set.
If [ Multi Shot Noise Reduction ] is set, direct printing is not possible. Select a
setting other than [ Multi Shot Noise Reduction ] and perform direct printing.
If you play back a
1
+
73
or
1
image with the camera or print an image
directly, the effect of the high ISO speed noise reduction may look minimal.
Check the noise reduction effect or print noise-reduced images with Digital
Photo Professional (provided software, p.350).
COP
Y