Canon EOS C70, Инструкция по эксплуатации

Страница: 144 / 215

Configuring Connection S etting s
144
Browser Remote
This section continues the connection settings wizard (
A
141). A user name and password are required to log
in to the Browser Remote application. In the function settings you will configure up to three different users for
single-user or two-user operation.
1 Select [Create New Func. Setting].
• Once you have added multiple function settings, you can select [Select Existing Setting] to reuse Browser
Remote settings that you saved previously.
2 Select the number of users.
3 Enter the user names and passwords as necessary.
• Single user: Select [Full: User Name] and [Full: Password].
Two users: Select [Camera: User Name], [Camera: Password], [Meta: User Name] and [Meta: Password].
• Enter the desired user name and password using the keyboard screen (
A
25).
4 Select [OK] twice.
• The function settings are saved to a [MODE] file.
5 Select the connection setting (SET1 to SET20) where to save the settings and then select [OK].
• The camera will connect to the network and will be ready to accept commands from the Browser Remote
application (
A
156).
Option s for [U s er Setting]
[One User (Full)]:
A single user who can access all Browser Remote screens.
[Two Users (Camera/Meta)]:
You will set up two user names and passwords, one who can access the main Browser Remote
screen to control the camera ([Camera]) and one who can access the metadata screen to
update the user memo and GPS information ([Meta]).
NOTES
• The same user name cannot be set for both the [Camera] and [Meta] users.
Other Connection Method s
This section explains how to configure communication settings using methods other than the WPS push button.
Ethernet Settings
1 In the [Network Type] screen, select [Ethernet ].
2 Make sure the Ethernet cable is correctly connected (
A
139) and select [Setup with Network Connection].
• Select [Setup without Network Connection] to only configure the settings, without connecting to the
network.
3 Set the IP address (
A
147).
4 Select [OK] to continue to configure the function settings.
• The communication settings are saved to an [NW] file.
• Continue with one the following procedures to configure the selected function’s settings.
FTP transfer (
A
141), IP streaming (
A
143), Browser Remote (
A
144)