Canon Duplex Color B1, Руководство по обслуживанию

Страница: 91 / 97

8
8
8-15
8-15
Adjustment > Overview > Hinge Pressure Adjustment
Adjustment > Overview > Hinge Pressure Adjustment
White Level Adjustment
1) Set A4 or LTR paper on the copyboard glass and close the DADF.
CAUTION:
If the paper with narrow width is used for white level adjustment, the adjustment may
not be complete properly.
2) Execute the service mode item.
Lv. COPIER > FUNCTION > CCD >
1
DF-WLVL1
3) Remove the paper from the copyboard glass and set it to the original pickup tray of DADF.
4) Execute the service mode item.
Lv. COPIER > FUNCTION > CCD >
1
DF-WLVL2
5) Set the paper to the copyboard glass again and close the DADF.
6) Execute the service mode item.
Lv. COPIER > FUNCTION > CCD >
1
DF-WLVL3
7) Remove the paper from the copyboard glass and set it to the original pickup tray of DADF.
8) Execute the service mode item.
Lv. COPIER > FUNCTION > CCD >
1
DF-WLVL4
Hinge Pressure Adjustment
1) Open the DADF and measure the lowest position where the DADF opens by itself.
2) Check that the height of the position measured in step 1) is within the standard.
Standard: 7 cm to 20 cm
3) If it is not within the standard, make the following adjustment.
If it is lower than 7 cm, turn the hex wrench counterclockwise.
If it is higher than 20 cm, turn the hex wrench clockwise.
MEMO:
Service tool: hex wrench (10 mm)
7 to 20 cm
Hex wrench