Chapter 4
4-21
6) Press [DF-WLVL2] on the touch panel
to highlight.
7) Press [OK].
- The machine executes auto adjustment
(duplex stream reading).
- When the adjustment ends normally, the
machine indicates 'OK!' on the screen.
8) Press the Reset key twice to end service
mode.
4.3.2
Adjustment at Time of
Parts Replacement
4.3.2.1
Adjusting the
Side Guide Plate
0006-2357
1) Remove the 4 mounting screws [1], and
detach the cover [2].
F-4-29
2) Loosen the mounting screws [3] [4];
then, move the original width volume
unit [5] to the front or the rear to make
adjustments.
3) Tighten the screws [3] [4].
4) Attach the cover after the adjustment.
5) Make a copy of the Test Chart once
again to see that the resulting image is as
indicated.
F-4-30
- if A>1 mm, move the volume unit [6]
toward the front.
- if B>1 mm, move the volume unit [6]
toward the rear.
[2]
[1]
[1]
[3]
[4]
[5]
Содержание DADF-N1
