Canon CLC 1130, Руководство по обслуживанию

Страница: 480 / 965

COPYRIGHT © 2002 CANON INC. CANON CLC1100/1130/1150/1160/1180 REV.0 MAR. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
10-27
CHAPTER 10 PAPER DECK
3) Remove the screw [3], and mount the
paper rear end guide plate [4] to suit the
new paper size. (Do not mount it if for
LTR.)
4) Likewise, remove the screw [5], and
mount the left/right guide plate [6] to suit
the new paper size.
5) Set the new paper size in the copier’s
service mode (OPTION>ACC> DK-P ).
Figure 10-321
4. Adjusting the Deck Registration
If the left/right registration (0 ±2.0 mm
standard) is needed, perform the following:
1) Slide out the compartment, and adjust the
position of the latch plate [1] of the deck
open solenoid (SL02) by turning the two
screws [2]. (At this time, use the
graduations [3] on the latch plate as a
guide.)
After adjusting the left/right registration,
be sure to check the position of the front cover.
(p. 10-21)
Figure 10-322
5. Adjusting the Position of the Roll
If the compartment cannot be opened or
closed smoothly, requiring adjustment of the
position of the roll, perform the following:
1) Remove the front cover.
2) Slide out the compartment fully, and turn
the four mounting screws [4] on the roll
support plate [3] so that the roll [1] is
about 3 mm from the floor [2]. (At this
time, use the graduations [5] on the front
side plate as a guide.)
Figure 10-323
[4] [3] [5]
[6]
(rear left of the compartment)
[1] [3] [2]
3 mm (approx.)
[4]
[5]
[2]
[1]
[3]