Canon 4573C002, Руководство по эксплуатации

Страница: 23 / 43

E16
2. Moving to the framing memory position
Once the Fr1P switch is pressed, the zoom starts to move toward the framing memory position at the preset speed.
When the zoom reaches to the framing memory position, it stops and stays there.
3. Canceling the movement to the framing memory position or switching to other zoom operation.
During movement to the framing memory position, the movement can be canceled and/or switched to other zoom
operation by any of the following operations.
[Zoom Framing Preset]
• Pressing the Fr1P switch again.
• Zoom operation with the zoom rocker seesaw can
immediately take over.
• Zoom operation with the Shtl switch can im-
mediately take over.
[Zoom, Focus Framing Preset]
• While is RET switch is held down, the on-air picture
(returned picture) can be viewed in the viewfinder.
1. Setting the framing memory position
Zoom (and focus) to the position that you want to store, while
holding this zoom (and zoom focus) position, press the Fr1P
switch while holding down the MEMO switch.
NOTE
This framing memory position is different from the shut -
tle memory position (Refer to "5-1-5. Suttle-Shot Func-
tion").The stored zoom position remains in the memory,
even after the power is turned off.
5 OPERATION
Zoom Rocker Seesaw
Shtl Switch
Fr1P Switch
MEMO
Switch
Framing Preset [Zoom]/[Focus]]/[Z+F] Setting
NOTE
The figure below is shown as an example. Actual state of the switch may look different if the function is al -
located to the different switch.
Fr1P function--------Assigned to the AUX switch by factory default.
1
If the manual focus operation is performed, set the focus op-
eration change-over knob to MANU. position.
NOTE
The lens may be damaged if the focus ring is turned
forcibly with the knob at the SERVO position.
5-2. FOCUS OPERATION
5-2-1. Manual Focus Operation
ZOOM FOCUS
REMOTE1 REMOTE2/
VIRTUAL
REMOTE3
MANU. SERVO MANU. SERVO
Focus Operation Change-over Knob
BT1-B051-E_E_CC.indd 16 2020/02/04 11:02:50