Cannondale SuperSix EVO, Дополнение к руководству пользователя

Страница: 16 / 28

16
SuperSix EVO OMS
Technical Information
Seat Post
151901 Rev. 0 (09/22)
Seat Post
To remove seat post:
1. Turn the binder screw with a 4mm hex key
counter-clockwise to loosen the clamp.
When clamp is loose, simply lift the seat
post up out of the seat tube.
To install the seat post:
1. Remove the binder clamp, clean it and
the frame pocket, then apply fresh
grease to the surface that will fit against
the frame, as shown on the next page.
Reinstall the binder clamp into the frame
pocket.
2. Apply fresh carbon friction paste to the
inserted section of the seat post and
inside the seat tube, including the surface
of the binder clamp which contacts the
seat post.
3. Insert the seat post into the frame.
4. Set the saddle height, observing the
minimum insert and within the limits of
the maximum insert for the frame and
tighten the clamp screw to 8 Nm.
5. Lower the rubber cover to the frame.
To adjust height:
1. Insert a 4mm hex into the clamp screw.
2. Loosen the binder screw sufficiently to
move the seat post up or down in the seat
tube.
3. Set the seat post position.
4. Tighten the binder clamp screw to 8 Nm.
To remove binder:
1. Remove the seat post.
2. Using a 4mm hex key, turn the screw
clockwise (tightening it) until the binder
clamp disengages from the threaded
base and can be lifted up out of the seat
tube. Take care not to let the binder
clamp fall into the seat tube.
Maintenance
Periodically remove the seat post and the
binder clamp assembly to clean, to inspect
for damage, and to renew the application of
grease and of carbon gel.
NOTICE
Do not exceed the specified torque.
Do not use any spray cleaners or solvents
to clean.
Do not adjust a seat post so it is bottomed
out in the frame.
For more information about carbon fiber
seat posts, see also “Care and
Maintenance of Carbon Fiber Seat Posts”
in your Cannondale Bicycle Owner’s
Manual.