Cannondale SuperSix EVO Neo, Дополнение к руководству пользователя

Страница: 18 / 36

16 137377 Rev 1.
English SuperSix EVO Neo - Owner’s Manual Supplement
Rear Wheel
The drive unit manufacture’s instructions
contain important details about handling
parts of the drive system. Read those
instructions now.
To prevent serious injury in the event of
accidental activation, turn the drive system
OFF before performing any work.
NOTICE
Take measures to protect the cables and
connectors from damage while the wheel is
removed.
To remove:
If the rear wheel must be removed in case
of a tire or tube replacement, the following
must be observed in the order presented:
1. Turn OFF the drive system. See
manufacturers‘ instructions.
2. Secure the bicycle in a bicycle work
stand with the rear wheel off the ground.
3. Loosen the guard screws and shift the
chainstay cable guard back and removed
over the screws and remove it.
4. Disconnect the battery cable and drive
unit cable connectors.
5. Loosen the drive unit axle nuts. An open
end wrench or and 8mm allen wrench
can also be used.
Dropouts are designed so that the nuts
and washers do not need to be comple-
tely removed to assemble/disassemble
rear wheel.
6. Carefully remove the wheel from the
dropouts.
To install:
1. Turn OFF the drive system. See
manufacturers‘ instructions.
2. Secure the bicycle in a bicycle work
stand with the rear wheel off the ground.
3. Position the rear wheel into the dropouts.
4. Align the axle washers protrusions with
the dropout slots, as shown in the figure
and install it onto each side of the axle.
5. Finger tighten both axle nuts.
On the power cable side of the rear hub,
make sure the cable is aligned in the slot
as shown. Make sure the cable will not
be pinched or crushed when tightening
the axle nut.
6. Tighten both axle nuts to the specified
torque. See hub instructions.
7. Re-connect the battery and hub cable
ends.
8. Install the chainstay power cable cover
with cables and tighten the screws to the
specified torque.