Cannondale FLASH 2010, Дополнение к руководству пользователя

Страница: 15 / 20

13
125238.PDF
68 mm ADAPTER INSTALLATION (Alloy frames only)
The following procedure should only be completed by a professional bike mechanic. The adapter IS NOT a repair part
and will only work in undamaged frames in good condition.
1. Remove the BB30 bearings and circlips from the bottom bracket shell.
2. Thoroughly clean and dry the inside of the bottom bracket shell. Remove any grease or dirt. Use a clean lint-free shop
towel dampened with alcohol to finish.
3. Apply Loctite™ 609 carefully to the bearing seat positions on both side of the inside shell.
4. Clean the outer surface of the adapter. Use a clean shop towel dampened with alcohol.
5. The groove side of the adapter must be located on the drive side. With a headset press, press the ADAPTER until the groove
side face is flush with the drive side face of the SI BB shell.
Allow at least 12 hours (at 72°F) for the Loctite to cure before installing the standard bottom bracket crankset.
Follow Loctite Technical Data Sheet
http://tds.loctite.com/tds5/docs/609-EN.PDF
Groove
KP009/
ADAPTER
DRIVE SIDE
(Headset press not shown)
KF365/
ADAPTER w/TOOL
Loctite™ 609
NOTICE
We strongly recommended that you use a swab to control the application and avoid spillage of the Loctite. Prolonged contact
with the frame finish may result in discoloration or damage. Be sure to immediately wipe up any spills and remove any
compound in contact with the painted surfaces.