ATTACHING THE ROD HOLDER
The locking rod holder incorporate a locking tooth design which can be easily adjusted every 15° with the soft grip knob. The
unique two piece design allows independent adjustment of the rod holder and the rod holder arm in two axes*. (Figure 6)
CAUTION: This rod holder is intended for use of up to 30 lb. test line only and is not recommended for use with
any tackle IGFA (International Game Fish Association) rated higher than 30 lb. A safety strap (not included) is
recommended for all applications.
NOTE: The rod holder assembly is not covered under warranty when used with tackle above 30 lbs. Equipment placed
in the rod holders and the loss thereof is the responsibility of the user and is in no way warranted by Johnson Outdoors,
Inc. Mounting must be in accordance with the above instructions to comply with the product warranty.
*Does not apply to Easi-Troll models.
To install the rod holder (Uni-Troll models):
1. Attach the rod holder elbow to the downrigger on the left side using the supplied spring and knob. (Figure 7)
2. Fasten rod holder to rod holder elbow using supplied spring and knob. (Figure 8)
The rod holder can be adjusted by loosening either knob until the locking teeth are free from each other. Rotate the rod
holder or arm to the desired position and re-tighten knob.
To install the rod holder (Easi-Troll models):
1. Attach the rod holder to the downrigger on the left side using the supplied spring
and knob. (Figure 9)
The rod holder can be adjusted by loosening the knob until the locking teeth are free
from each other. Rotate the rod holder to the desired position and re-tighten knob.
Figure 6
Figure 8
Figure 7
Figure 9
cannondownriggers.com | 9
©2015 Johnson Outdoors Marine Electronics, Inc.
ASSEMbLy & INSTALLATION
