Cannon GMK10025, Инструкция пользователя

Страница: 6 / 10

Page 5.
Thermostat LCD
Full display
ROOM
TIME
AM
MO
ROOM
SET
TIME
AM
PM
SU MO TU WE TH FR SA
PROG MANUAL AUTO
LCD Display features
1. Temperature of Room in ( C or F)
2. Transmitting indicator
3. Battery low indicator
4. Fan operating and speed
5. Fire indicator(low, medium or high)
6. Selected Temperature in C or F)
7. Time of day (in AM or PM)
8. Day of week
9. Programming mode
10. Manual mode
11. Automatic mode ° °
° °
Initial Display on set up
The display when the thermostat is
initially turned on or when batteries are
replaced shows;
Current room temperature;
default clock display;
Default day of the week display.
1
4 5
6
7
8
9 10
11
3
Page 14.
Settings
Change between °C and °F
Teaching RF thermostat ID code to control unit.
Restore factory default settings.
The automatic mode factory default settings can be restored to those
found on page 10.
With the thermostat off, press the following sequence of buttons:
. ‘P ’, ‘T ’, ‘T ’,‘DOWN ’
The thermostat temperature display can be set to°C or °F. The default is °C.
With the thermostat off, press the following sequence of buttons:
. ‘P ’, ‘T ’, ‘T ’ ,‘A/M ’
Please note, thermostat settings need to be actioned within a period
of 15 seconds total.
2
1. Leave the remote thermostat in the off or stand by position.
(the room temperature and time only will be displayed)
2.The heater must be turned off at its switch located on the rhs
of the heater.
3.Turn off the power point and fully remove power cord plug.
(if there is no access to the power cord plug then try switching off
the power switch which the installer has fitted externally)
4.Wait at least 30 seconds and then plug the cord plug back into
the power point and switch on the power point,(or switch on the power switch)
do not operate any heater buttons.
5.You have now 15 seconds to perform the code learning procedure.
6.With the remote thermostat unit still off, aim the control at the heater and
press the button(s) in sequence within 2 seconds
The seqence of pressing buttons is
7.When successful, the display will show (learning code) very briefly.
“P, T, T, UP ”
“LC”