Cannon FITZPIB, Инструкция пользователя, Страница: 8 / 24

8
All cleaning should be carried out when the heater is cold. Nor-
mally the heater should only need wiping with a lint - free damp
cloth. Any stubborn stains can be removed with a non-abrasive
spray on cleaner. If an abrasive cleaner is used the paint finish will
be damaged.
Internally the heater should only be cleaned by a licensed service
person listed in this manual.
If your heater requires attention contact your supplier or licensed
service person listed in this manual.
Important:
The appliance should be inspected before use and at least annu-
ally by an authorised service person. More frequent cleaning may
be required due to excessive lint build-up from carpeting, bedding
materials, pet hair, etc.
It is imperative that control compartments, burners and circulating
air passage ways of the appliance be kept clean.
Do not use this fire if the glass is cracked or with the glass safety
screen removed.
Cleaning.
User instructions continued
17
23. Gas control layout is as indicated in figure 33.
Pressures for ‘Burner full on’ and ‘Burner low flame’ are fac-
tory set, however if pressures need to be checked or adjusted
follow the procedures described below and on the next two
pages.
To check control outlet pressure at burner ‘Full on” and ‘Low Flame”
positions remove the plastic cap from the regulator adjustment lo-
cation as indicated in figures 34 (a) & (b).
24 The pressure point is closed with a captive screw. Turn screw 6
revolution anticlockwise to open the pressure point as indicated on
figure 35 (a) and place manometer tube over the test point as per
figure 35 (b).
33
Gas pressure point
34
35
Gas control