Cannon CT-500, Инструкция по эксплуатации

Страница: 22 / 49

14 CT-500 Instruction Manual
Figure 9: Secure White Power Supply Connectors
10. Attach the two matching black power supply connectors together. Refer to Figure 10.
Figure 10: Connect Black Power Supply
11. Carefully slide the motor-stirrer into place on the motor support pad, impeller shaft down with
"cut out" portion corresponding to the location of the TE cooler as shown in Figure 11.
Figure 11: Lower Motor-Stirrer
12. Align the motor line cord so it points toward the rear of the bath. The motor-stirrer should now lie
flat on the top of the bath.
13. Lower the motor-stirrer power cord down through the vertical channel in the rear of the unit.
14. Loosely install the front housing using the screws previously removed, but do not yet tighten the
screws.