Cannon Tools NEILSEN CT2594, Инструкции и сборка

Страница: 8 / 12

6
5. ASSEMBLY
Secure the right and left Base Supports to the bottoms of the frame, using Screws,
Spring Washers , and Nuts for each Base Support. Attach Seek help to set
upright.
Connect each of the four support bars to the post and base section with bolts , flat
washers , lock washers and nuts .
6. OPERATION
Before the first use, check for proper hydraulic oil level in the system. Then
thoroughly test the hydraulic ram for proper operation prior to its actual use.
1. Pour a teaspoon of good quality, air tool lubricant into the air supply inlet of the
foot pedal. Connect to the air supply and operate for 3 seconds to evenly
distribute lubricant.
2. Purge air from the hydraulic system. See Bleeding the Hydraulic System in the
Maintenance section.
OPERATING THE SHOP PRESS
WARNING! Ensure that you read, understand and apply the safety instructions
and warnings before use.
1. Place the heel blocks on the adjust beam , then insert a workpiece on the heel
blocks.
2. Lift or lower the bed frame with the hand winch until it is in position. Insert a
support pin into the left and right posts beneath the bed frame. Lower the bed
frame so it rests on the pins. Secure the pins with retaining rings.
3. Close the release valve by turning it until it is firmly closed.
4. Connect the air inlet to the air compressor. Set the compressor
’
s air pressure
regulator at no more than 120 psi. Turn on the air compressor to permit air to flow
to the pump assembly. Continue pressing until the serrated saddle nears the
workpiece, then turn off the compressor.When an air source is unavailable, pump
the handle until the serrated saddle nears the workpiece.
5. Align the workpiece and ram to ensure center-loading.
6. Turn on the compressor (or pump the handle) to apply load to the workpiece.
7. When the work is done, turn off the compressor (or stop pumping the handle).
Slowly and carefully remove load from the workpiece by turning the release valve
counterclockwise in small increments.
8. Once the ram has fully retracted, remove the workpiece from the bed frame.
9. Disconnect the air inlet fitting from the air source when finished for the day.