CANGAROO DOLCE 7151, Инструкция по эксплуатации

Страница: 15 / 52

15
•
Be careful when adjusting the position of the tray, the footrest and
when unfolding or folding the chair, as there is a risk of pinching your
fingers.
•
Use the tray always in combination with safety belts! The tray is not
intended to protect the child from falling.
•
Never lift, move, fold, adjust or repair the seat when there is a child in
it. This can injure the child.
•
Always before use, check the functioning of the locking mechanisms.
•
Before placing the child in the seat, make sure that it is fully unfolded
and locked in the open position and that all locking mechanisms are
tightly closed! This will prevent the child from being injured by sudden
folding of the chair.
•
Do not make changes, improvements or modifications to the
construction, because this may risk the safety of your child. If a
problem arises during the use and operation with the product, contact
an authorized repair shop or the sales agent you bought the high chair
from for consultation or repairs.
IMPORTANT! The diagrams and figures in this instruction are illustrative and indicative
only. Follow exactly the instructions and sequence for assembling and operating with
the product. Check the securing of the fixation after each operation. Fixing a certain
position in most cases is accompanied by a clicking sound.
COMPONENTS – FIGURE А :
1. Seat unit; 2. Serving tray; 3. Support frame for legs;
4. Support tube (leg) - 4 pieces; 5. Stopper (4 pieces); 6. Plastic tip for the stoppers (4
pcs.); 7. Bolt for fixing the tips (4 pcs.); 8. Plastic connector pin (8 pcs.).
PRODUCT ASSEMBLY – FIGURE B: Strictly follow the instructions and
sequence for assembling the product as shown in the diagrams. WARNING!
Make sure that the base is assembled correctly and is stable, this ensures the
safety of your child!
Step 1: On both sides of each support tube (leg), insert a plastic connector pin
so that it is fixed well in the corresponding hole of the tube. Push until you hear
a clicking sound and the end of the pin comes out (see figures 1 and 2).
Step 2: To install the four support tubes to the seat, thread each support tube
(leg) through the hole in the support frame and insert it into the connecting
hole of the seat. Press until you hear a clicking sound and the pin comes out of
ASSEMBLY INSTRUCTIONS