50
IDENTIFYING MINOR FAULTS
REMEMBER! the oven and the dishwasher cannot be used in the same time.
Should the dishwasher fail to operate, before contacting the Service Centre, make the
following checks:
FAULT
CAUSE
REMEDY
Plug is not connected correctly
Connect electric plug
O/I button has not been pressed
Press button
No electricity
Check the electricity supply
Door is open
Close door
See causes for No 1
Check
Water tap is turned off
Turn water tap on
Programme selector is not at
correct position
Turn programme selector to correct
position
The inlet hose is bent
Eliminate the bends in the hose
The inlet hose filter is blocked
Clean the filter at the end of the
hose
Filter is dirty
Clean filter
Outlet hose is kinked
Straighten outlet hose
The outlet hose extension is not
correctly connected
Follow the instructions for
connecting the outlet hose carefully
The outlet connection on the wall is
pointing downwards not upwards
Call a qualified technician
Excessive amount of detergent
Reduce amount of detergent
Item prevents arm from rotating
Check
Plate and cup filter very dirty
Clean plate and cup filter
6 - On electronic appliance
without a display: "Eco"
indicator light and indicator
light "No 1", with audible signal
Water inlet tap turned off
Switch off the appliance - Turn on
the tap - Re-set the cycle
Lift outlet hose to at least 40 cm
above floor level
5 - Spray arm is not heard to
rotate
Position of outlet hose is too low
1 - Machine completely dead
2 - Machine does not draw
water
3 - Machine does not discharge
water
4 - Machine discharges water
continuously