Candy RO H8A2TCEX-S, Инструкция по эксплуатации

Страница: 71 / 132

EN
71
PAUSING THE MACHINE
l
Keep the START/PAUSE button pressed
for about 2 seconds (the name of the
programme and the residual time display
will flash, showing that the machine is
paused).
l
Press the START/PAUSE button again to
re-start the programme from the point it
had been paused at.
CANCELLING THE SET PROGRAMME
l
To cancel the programme, turn the
programme selector to the
OFF position.
If there is a break in the power supply
whilst the machine is operating, when
the power is restored, the machine will
restart from the beginning of the phase it
was in when the power was lost.
l
This button allows to delay the start of the
programme from
30 minutes ( 1 hour on
some models) to 24 hours in 30 minutes
intervals ( 1 hour on some models).The
delay selected is shown on the display.
l
After pressing the START/PAUSE button
the time showed decrease minute after
minute.
l
It's possible transform a cycle from
automatic to programmed, up to
3
minutes after the start of the cycle.
l
The progressive pressure increases the
time in
10 minute intervals. After this
selection to reset the automatic drying
functioning is necessary to switch off the
dryer.
l
In case of incompatibility, all indicator
lights flash quickly for 3 times.
This button allows you to store the options
set on a cycle.
MEMORY:
when the cycle is running push the button
MEMO for 3 seconds. The writing MEMO
(all the digit on some models) will blink for 2
seconds and the options connected to the
cycle selected will be set.
RECALL:
after the selection of the cycle push the
button
MEMO for recall the stored options
(not the cycle).
l
This button allows to set the desired
dryness level editable option up to
5
minutes after the starting of the cycle:
Ready to Iron : it leaves the garments
slightly wet to facilitate ironing.
Dry Hanger : to get garment ready to
be hang.
Dry wardrobe : for laundry that can be
directly stored.
Extra-dry : to get completely dry
garments, ideal for full load.
l
This appliances is equipped with Drying
Manager function. On automatic cycles,
each level of intermediate drying, prior to
the reaching the selected one, is
indicated by flashing the light indicator
corresponding to the degree of drying
reached.
DELAY START button
Opening of the porthole with delayed
start set, after re-closing the porthole,
press start again to resume the counting.
TIME CYCLE SELECTION button
MEMO button
The delay start function can't be
memorized.
DRYING SELECTION button