Candy CVG6PX LPG, Инструкции по использованию - Советы по установке

Страница: 29 / 44

29 29
Fig. 2.2a
LIGHTING THE BURNERS
To ignite the burner, the following
instructions are to be followed:
1. Press in the corresponding knob and
turn counter-clockwise (fig. 2.2a or
2.2b) to the full flame position marked
by the “ ” or “ ” symbol; hold the
knob in until the flame has been lit.
In the case of a mains failure light the
burner with a match or lighted taper.
2. Wait for a few seconds after the gas
burner has been lit before letting go of
the knob (valve activation delay).
3. Adjust the gas valve to the desired
position.
If the burner flame should go out for some
reason, the safety valve will automatically
stop the gas flow.
To re-light the burner, return the knob to
the closed “ ” position, wait for at least
1 minute and then repeat the lighting
procedure.
Note: If your local gas supply makes it
difficult to light the burner with the knob set
to maximum, set the knob to minimum and
repeat the operation.
DUAL BURNER - SOME MODELS
ONLY
The Dual Burner is a very flexible burner
which allows different regulations and
optimal cooking.
It is composed by one inner and one outer
crown: the inner and outer crown can be
used together or separately .
The Dual burner is
controlled by two
separate knobs:
■ one knob for the inner crown
only (“ ” symbol identifying the
control knob);
■ one knob for the outer crown only
(“ ” symbol identifying the control
knob).
The Dual burner can be used:
■ as a small burner (flame produced
only by the inner crown);
■ as a Ultra-rapid burner (flame
produced only by the outer crown);
■ as a high-power burner (all flames
produced simultaneously by inner and
outer crown).
IMPORTANT: After using the
dual burner check both the
control knobs are in the
closed “ ” position.
Fig. 2.2b