EN - 14 -
Conformity Information
• This appliance is designed for use at an ambient temperature within the 16°C - 38°C
range.
Tips For Saving Energy
1– Install the appliance in a cool, well ventilated room , but not in direct sunlight and
not near heat source (radiator, cooker.. etc). Otherwise use an insulating plate.
2– Allow ward food and drinks to cool down outside the appliance.
3– When thawing frozen food, place it in the refrigerator compartment. The low tem-
perature of the frozen food will help to cool the refrigerator compartment when it is
thawing. So it causes energy saving. If the frozen food is put out, it causes wastage
of energy.
4– W hen placing, drinks and slops they must be covered. Otherwise humidity in-
creases at the appliance. Therefore the working time gets longer. Also covering
drinks and slops helps to save smell and taste.
5– W hen placing food and drinks, open the appliance door as briefly as possible.
6– Keep close the covers of any different temperature compartment in the appliance
(crisper, chiller ...etc ).
7– Door gasket must be clean and pliable. Replace gaskets if worn.
• If the problem persists after you have followed all the instructions above, please
consult to the nearest Authorised Service.
• The appliance you have purchased is designed for home type use and can be used
only at home and for the stated purposes. It is not suitable for commercial or common
use. If the consumer use the appliance in a way that does not comply with these
features, we emphasise that the producer and the dealer shall not be responsible
for any repair and failure within the guarantee period.
Energy Saving
For better energy saving we suggest :
• Installing tge appliance away from heat sources and not exposed to direct sunlight
and in a well ventilated roo.
• Avoid putting hot food into the refrigerator to avoid increasing the internal temperature
and therefore causing continuos functionaliting of the compressor.
• Do not excessively stuff foods so as to ensure proper air circulation.
• Defrost the appliance in case there is ice to facilitate the transfer of cold.
• In case of absence of electrical energy, it is advisable to keep the refrigerator door
closed.
• Open or keep the doors of the appliance open as little as possible
• Avoid adjusting the setting to temperatures too cold.
• Remove dust present on the rear of the appliance
