Candy CMDG 919 Series, Инструкция для пользователей и по установке

Страница: 14 / 30

3.1The cooker hoods should be placed
at a distance of 65-75cm from the
cooking surface for best effect. See
pic1.
3.2 To install onto the wall every
100mm drill 3 holes of Ø8mm on a
suitable place in line with the hook on
the hood.
3.3 Insert expended screws into the
holes.
3.4 Fix the hook on the wall. See pic2.
3.5 Exhaust mode:
Add the soot tube to the one way valve,
and put it outdoor. See pic3.
Circulation mode (no tube required, see pic 5):
Charcoal filter/s (optional accessories) must be used in the case of the
circulating mode (please see also chapter 7.1).
If necessary, proceed to fit as follows, depending on the model type
purchased:
-
if the hood features round charcoal filters, fit the charcoal filter by
turning anti-clockwise.
-
if the hood features square magnetic filter, put is in right position
and fix with gentle pressure.
Charcoal filter/s:
The charcoal filters must be periodically replaced depending on extent
of operation – on average every 6 months. To remove the charcoal
filters, proceed as follows, depending on the model purchased:
-
if the hood features round charcoal filters, remove the charcoal
filter by turning clockwise.
-
if the hood features square magnetic filter, pull gently to release.
3.6 Put the two U-shaped sections on the body (see pic 3A), then put
the glass in the lead way, use four screws to fix the glass (see pic3B),
then pull out the inside U-shaped section with a suitable height in the
lead way (see pic 4). Finally, drill 2 holes of Ø8mm on a suitable place
in line with the plate. Repeat 3.3(see pic4A), tighten the two screws
(see pic 4B).