Candy CDF 715 T, Инструкция пользователя

Страница: 4 / 25

6
“1/2 FLEXI” button
To ensure that your dishwasher meets all
your requirements, this button allows you
to select:
1) Half Load Top Basket
By selecting this option dishes
are washed in the top basket
and cutlery in lower basket.
2) Half Load Lower Basket
By selecting this option dishes
are washed in the lower basket
only.
"DELAY START" button
Dishwasher start time can be set with this
button, delaying start from 1 to 23 hours.
Proceed as follows to set a delayed start:
■
Press the "DELAY START" button ("00"
will appear on the display).
■
Press the button again to increase the
delay in hours (each time the button is
pressed the delay is increased by 1 hour
to a maximum of 23).
■
To start the countdown, press the
selected program button (the relevant
LED will stop blinking and remain on and
the start time delay will be shown in the
display).
At the end of the countdown, the program
will automatically start and the length of the
selected cycle will be shown in the display.
Proceed as follows to cancel a delayed
start:
■
Hold the selected program button down
for at least 5 seconds.
■
Delayed start cancellation is confirmed
when the selected program LED starts to
blink. The display will go blank and the
program end LED will light (any selected
options will also be cancelled and the
corresponding LEDs will turn off).
■
At this point, a new program and option
buttons must be set to start a new
program as indicated in the
"PROGRAM
SETTINGS" section.
Buzzer mute
The buzzer may be muted as follows:
■
With the dishwasher off, hold down the
second option button (from the left) while
simultaneously pushing the "ON/OFF"
button.
■
"b1” will appear on the display to indicate
that the buzzer is on.
■
Press the same option button (second
from the left) within 5 seconds ("b0" will
appear on the display to indicate that the
buzzer is off).
■
Wait for a buzzer to sound to indicate
that the settings were saved.
■
To turn the buzzer on again, follow the
same procedure ("b1" will appear on the
display to indicate that the buzzer is on).
WARNING!
To ensure the correct operation of
the anti-overflow safety device, it is
recommended not to move or to tilt
the dishwasher during operation.
If it is necessary to move or to tilt the
dishwasher, first make sure the
washing cycle is finished and that no
water is left in the tank.
AUTOMATIC FAULT SIGNALS
7
Turn off the dishwasher, open the
inlet hose and reset the cycle.
Check if the drain tube is bent or if
the siphon or filters are clogged.
If the problem persists, contact
Customer Service.
Check if the drain tube is bent or if
the siphon or filters are clogged.
If the problem persists, contact
Customer Service.
Contact Customer Service.
Contact Customer Service.
Clean the filter plate.
If the problem persists, contact
Customer Service.
FAULTS CAUSE SOLUTION
E2
appears on the display and
the buzzer sounds.
E3
appears on the display and
the buzzer sounds.
E4
appears on the display and
the buzzer sounds.
E5
appears on the display and
the buzzer sounds.
E6
appears on the display and
the buzzer sounds.
E8
or
Ei
appear on the display
and the buzzer sounds.
No water (inlet hose closed).
The machine cannot drain water.
Water leak
Electronic temperature control fault.
Electronic control fault.
The water heating element is not
working correctly or the filter plate is
clogged.
The dishwasher is able to signal a series of faults in the display.