7
The water-stop device protects against water damages caused by leaks on the fill
hose which could develop due to natural ageing of the hose.
In the water-stop system the leaking water fills the corrugated hose and activates a
stop valve which cuts off the water supply to the machine.
This fault is shown by a red sector on the window «
A
».
Would this occur, please refer to your Service Agent.
If the hose is not long enough for correct connection, it must be replaced with a longer
one. The hose can be obtained from your Service Agent.
WATERCONTROL-SYSTEM
Red button blocked
valve indicator
Safety antitwist device
(press and twist to
remove the washer)
A
6
At the end of the last 3 hours (at the end
of countdown) the
3h
LED will stop
blinking and remain on to indicate the
washing phase and the program will start
automatically.
If countdown has not ended, whereby
the program has not yet started, it is
possible to change or cancel the delayed
start and select another program or to
select/unselect the option button, proceeding
as follows:
■
Hold down the selected program button
for at least
5
seconds (the corresponding
LED will start to blink while the set time
LED will stop blinking and remain on).
■
Press the
"DELAY START"
button to
set another delayed start time (the
corresponding time LED will turn on) or
cancel delayed start (corresponding time
LEDs will all turn off).
■
A new program can be set after a
delayed time has been changed or
cancelled (the corresponding LED will
stop blinking and remain on) or an option
button has selected or deselected.
Fault signals
If malfunctions or faults occur when a
program is running the LED that
corresponds to the selected cycle (2 LEDs
for the
"COLD RINSE"
program) will blink
rapidly.
In this case, turn the dishwasher off by
pressing the
"ON/OFF"
button. After
checking to make sure the water intel hose
tap is open, that the drain hose is not bent
and that the siphon or filters are not
clogged, set the selected program again. If
the anomaly persists, contact Customer
Service.
IMPORTANT
This dishwasher is equipped with an
anti-overflow safety device which will
automatically empty any excess
water should a problem occur.
WARNING!
To ensure the correct operation of
the anti-overflow safety device, it is
recommended not to move or to tilt
the dishwasher during operation.
If it is necessary to move or to tilt the
dishwasher, first make sure the
washing cycle is finished and that no
water is left in the tank.
Содержание CDF 615 A
Страница 24: ...46 K 3 6 9 K 3 6 9 9 6 3 3 6 3 3 5 K 9 2 K ON OFF K 9 1 5 5 1 O X 1 5 H 5 Watercontrol K A 47 ...
Страница 30: ......
Страница 31: ......
Страница 33: ...04 09 41012135 A Printed in Italy Imprimé en Italie EN HR HU PL SL EL CZ ...