Daily Use
23
Replacing the light bulb
The inside light is of LED type. To replace the light bulb, please contact a qualified technician.
Replaceable (LED only) light source to be fitted by a professional only. This product contains a light source of energy
efficiency class F.
Troubleshooting
Caution!
Before troubleshooting, disconnect the power supply. Only a qualified electrician or
competent person must perform any troubleshooting not described in this manual.
Important!
There are certain sounds that are emitted during normal use (compressor, refrigerant circulation).
Problem
Possible cause
Solution
Appliance does not work
Temperature regulation knob is set to
coldest.
Set the knob to another setting and switch
on the appliance.
Mains plug is not plugged in or is
loose.
Insert mains plug.
Fuse has blown or is defective.
Check fuse, replace if necessary.
Socket is defective.
Mains malfunctions are to be corrected by
an electrician.
Appliance freezes or
cools too much
Temperature is set to too cold, or the
appliance is running on the coldest
setting.
Turn the temperature regulator to a warmer
setting temporarily.
The food is not frozen
enough.
Temperature is not properly adjusted. Please consult the initial Temperature
Setting section.
Door was open for an extended
period.
Only keep the door open for as long as
necessary.
A large quantity of warm food was
placed in the appliance within the last
24 hours.
Turn the temperature regulator to a colder
setting temporarily.
The appliance is near a heat source.
Please consult the section on installation
location.
Heavy buildup of frost on
the door seal.
Door seal is not airtight.
Carefully dry the leaking sections of the
door seal with a hair dryer (set to a cool
setting). At the same time, shape the warmed
door seal by hand to make sure it sits
correctly.
Unusual noises
Appliance is not level.
Re-adjust the feet.
The appliance is touching the wall or
other objects.
Move the appliance slightly.
A component, e.g., a pipe, at the rear
of the appliance is touching another
part of the appliance or the wall.
If necessary, carefully bend the component
out of the way.
Water on the floor
Water drain hole is blocked.
See the Cleaning and Care section.
Side panels are hot.
It’s normal. Heat exchange parts are
located at the sides.
Wear gloves before touching the sides,
if needed.
If the malfunction persists, contact the Service Centre.
This data is necessary to help you act quickly and correctly. Write down the necessary values here, be sure to refer to the rating plate.
